|
|
|
Miter Saws Framing The Way We Cut
ack in the old days a miter saw and a basic power miter
miter saw held a blade that saw.
was attached to a box. The
blade was perfectly angled to When it comes to fancier versions
create 90 and 45 degree angles of the miter saw, then you must
with a simple adjustment. This have power. In general, a miter
manual tool easily cut through saw or radial saw with allow
frame, crown, or chair mouldings. users to adjust the degree of the
It even made the cut when it came cut relative to the fence which
to exterior corners on baseboard guides the wood by a single
mouldings. Perhaps that is why degree. There are standard stops
there are some people who still at the most common settings of
own and use this type of manual 15, 30, 45, and 90 degrees. When
saw and find it perfectly wood is securely anchored against
acceptable. the fence, a 45 degree cut will
perfectly match a corresponding
It’s All About the Power 45 degree cut going in the
opposite direction for the
Today, it seems that power is perfect mitered corner to frames
where it’s at, even when it comes or window mouldings.
to basic tools. The greatest
advantage to using a power saw is Another Angle to Miter Saws
the cleanliness of the cut. A
hand saw, no matter how skilled Beyond picture frames and crown
the craftsman is, still leaves moulding, there is a whole new
the cut wood a bit more ragged angle to miter cuts that make
than a power saw. And with the table tops, counters and other
rising popularity of all power furniture safer and more
tools, there is not a significant appealing. It is the compound
cost difference between a manual miter saw. A compound cut gives
counters and table tops a unique
bevelled edge that rounds the A panel saw is the first step in
sharp corners and makes them less projects such as cabinetry. It is
likely to snag or scratch someone designed to cut the face and
walking by. The gradual angles of sides of the cabinet by cutting
the cut shape the edge and a large panels of plywood into the
little sanding smoothes it to rectangles. Then the miter saw
perfection. would be used to frame and face
the front of the cabinet door or
Radial arm saws can create a draw, usually made of a fine
similar effect. It just requires hardwood, so that there were
a couple of passes of the blade bevelled edges and a complete
at different angles to complete decorative front.
the look. The Dewalt radial arm
saw was a good model, but is no It is easy to see that a number
longer manufactured in the U.S. of saws are used to make up a
(Production stopped in 1985). complete workshop. If you have to
However, this workhorse found in substitute a miter saw for
many of the best workshops can another, then make the radial saw
still be serviced throughout the your choice.
country.
About the Author:
Being very excited about radial arm saw and power compound miter saw, Jack Blacksmith has been authoring a variety of short articles in the area. Recording his experience in publications on miter saws Jack is a tool expert.
Read more articles by: Jack Blacksmith
Article Source: www.iSnare.com |
|
